
17
WB-200 SERIES INTERCOM SYSTEM — WBS-200 DUAL CHANNEL WIRELESS BASE STATION
6. ACCESSORY OPTIONS
In this section we will explain the different available options for the base station WBS-200 unit.
PROGRAM INPUT TRANSFORMER (IT-DA)
In order to improve the common mode rejection ratio and get a galvanic isolation with the
previous part of the audio system, an input transformer for the program input is available.
The provided transformers fulfil the isolation rule of 1.5 kV.
PA OUTPUT TRANSFORMER (OT-DA)
In order to get a galvanic isolation with the next part of the audio system, an output
transformer for the PA output is available.
The provided transformers fulfil the isolation rule of 2 kV.
DIRECTIONAL ANTENNA (DA-P6060)
This accessory is provided with an extension 2 meter low loses coaxial cable. The antenna
must be installed on the wall pointing out the desired area and covers a focused beam of 60
degres H by 60 degres V. The panel antenna must be installed on the unit to cover the local area
around the unit.
7. SPECIAL OPERATIONS
In order to set-up some of the master station possibilities, the unit must be opened removing
the six screws of the unit top cover, and for the input and output transformers placement also the six
screws of the unit bottom cover, to solder the transformers.
NOTE: This type of operations takes place with the unit is opened; the best thing should be to carry it
out by a qualified technician.
DANGER: Before opening the unit, disconnect it from the mains. It is important to indicate that
although the unit is switched off (with the power switch in 0 position), if it keeps being connected to
the mains there are different parts of the unit that are subjected to high voltage.
CAUTION: Protect the master station from the rain and moisture, mostly if it is open. If liquid is spilled
into the unit, disconnect it from the mains and consult a qualified service technician.
Kommentare zu diesen Handbüchern