7
with the wireless beltpack that is calling at this time (if the call is from the base station does not
indicate any number associated), if the vibrator is enabled (see vibrator on/off section for more
information) will be vibrate, and if the buzzer is enabled (see buzzer on/off section for more
information) an intermittent sound will take place during about three seconds.
3.5 OLED DISPLAY
The wireless beltpack has a colour OLED display of 96x64 pixels to show the
messages and the configuration of the unit at a glance.
The display, in idle mode, indicating the base station coverage , the
time that the beltpack remain on , the battery level of the trunk , if it is on the
microphone , phantom power , microphone extra gain , buzzer , the
registration number of the beltpack , the name of the
beltpack , the vibrator and the volume level of the headphones
After thirty seconds of inactivity, the display and the LEDs of the
wireless beltpack, lower its brightness to save power, and after another thirty seconds the display
goes off and the LEDs down light intensity again.
If you press any key, receive a call or plug the wireless beltpack charger, the display will
switch back on and the LEDs will return to their scheduled light intensity.
3.6 MENU SWITCH
When the MENU switch is pressed and there isn't active any message on the wireless
beltpack, appears the menu of the beltpack, with which various parameters of the beltpack
can be configured. If any beltpack message or the beltpack menu are active, the
system return to normal mode.
When the beltpack menu is activated, the front panel VOLUME switches move the cursor
up/down the options, the MENU (ESCAPE) switch exit the MENU and the
SELECT (ENTER) switch access the parameter that is currently
selected.
3.6.1 MICROPHONE GAIN
The microphone gain adjustment menu allows
attenuating or amplifying the mic signal, from 1 (minimum
value) to 16 (maximum value).
The microphone gain can be adjust directly (without menu), pressing the MIC
ON/OFF switch and at the same time the UP (to increase the gain) or DOWN (to
decrease the gain) front panel VOLUME switches.
The MIC GAIN, it is stored in the unit. Press again to switch on if necessary.
FACTORY PRESET:
to MAX position (Dynamic mic.)
3.6.2 MICROPHONE PHANTOM POWER
The microphone PHANTOM power could be activated or
disabled with the beltpack MENU. If an electret microphone
is used, the PHANTOM power must be enabled and if a
dynamic microphone is used, the PHANTOM power must be disabled. The microphone
PHANTOM power is 9 VDC.
The microphone phantom power can be enable/disable directly without
accessing the beltpack menu, pressing the MIC ON /OFF switch, and at the
same time the upper panel VOLUME UP switch .
WBP-210 SINGLE CHANNEL WIRELESS BELTPACK
(16 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern