Altair WBP-200 Anleitung zur Fehlerbehebung Seite 1

WBP-212WIRELESS DUAL CHANNEL MANAGER BELTPACKWB-200 SERIES WIRELESS INTERCOM SYSTEMOWNERS MANUAL ISSUE 29J10

103.7.8 CHANGING THE BELTPACK NAMEWith the Name MENU, the user can change the beltpackname that appears on the display , under thebeltpack registratio

113.7.12 KEYBOARD LOCKThe keyboard lock is useful to prevent unwanted useand to avoid unwanted key press. With this menu option youcan lock the keys c

12able to be registered until the deregistration of some beltpack is made or deregister all thebeltpacks registered in the base station (consult the b

13If the wireless beltpack is turned on, and you press the ON/OFF button for a while, the beltpack shows the battery status.3.9 VOLUME UP/DOWN SWITCHE

144. SPECIAL OPERATIONS In order to set-up some of the wireless beltpack possibilities, the unit must be opened removingthe bottom auxiliary cover, re

156. TROUBLESHOOTING GUIDEWHEN:POSSIBLE CAUSES AND SOLUTIONS1) Abnormal low range. a) With the beltpacks on, switch off the base station, wait for 30

167. BATTERY CHARGER ALTAIR WBPC-210The battery charger ALTAIR WBPC-210 allows tocharge up to four beltpacks ALTAIR WBP-210/WBP-212simultaneously. The

177.3 BELTPACK BATTERY CHARGEThe battery charger ALTAIR WBPC-210 has four connectors to allow the charge up to fourwireless beltpacks at the same time

188. TECHNICAL SPECIFICATIONSPREAMPLIFIERMICROPHONE TYPE:• Dynamic or electret.INPUT IMPEDANCE:• 4K7.NOMINAL LEVEL:• -45 dBu.PHANTOM VOLTAGE:• +9 VDC

199. WARRANTY This unit is warranted by Equipos Europeos Electrónicos to the original user, against flaws inthe manufacturing and in the materials, f

21. INTRODUCTION...

20WBP-212 WIRELESS DUAL CHANNEL MANAGER BELTPACKEuropean Union Waste Electronics Information Unión Europea Información sobre residuos electrónicos

31. INTRODUCTIONCongratulations on your purchase of the ALTAIR single channel wireless beltpack WBP-212 ofthe WB-200 series wireless intercom system.

42. SWITCHES, CONTROLS, ADJUSTMENTS AND CONNECTORSSwitches, controls, adjustments and connectors that you can find in your ALTAIR intercombeltpack. Th

53. OPERATIONThe WB-200 series intercom system are designed to allow maximum easy communicationsoperation between the different control areas in music

6NOTE: Headphones could be with a double or single muff. In case of using a double muffheadphone, the two speakers should be wired in parallel mode.3.

7Press and hold the Channel Select switch and when the AB lamps flashes (wait 2 seconds),start your message from the headset microphone. When done, re

83.7 MENU SWITCHWhen the MENU switch is pressed and there isn't active any message on the wirelessbeltpack, appears the menu of the beltpack, wit

93.7.4 SIDETONE GAIN ADJUSTMENTThe sidetone gain adjustment allows attenuating or amplifyingthe own mic signal that we listen in our headphones. The s