Altair EF-200 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 12)

BP-200 SINGLE CHANNEL WIRELESS BELTPACK.

6. BATTERY CHARGER ALTAIR WBPC-200

The battery charger ALTAIR WBPC-200 allows

to charge up to four beltpacks ALTAIR WBP-200

simultaneously. The charge time is approximately of

three hours with the batteries totally discharged.

After this 2-3 hours time, the charger sets to trickle

(maintenance) mode and can be left alone in the

charger. For a full charge, it is recommended a 2

hours minimum charging in this state.

CHANGING THE VOLTAGE AND THE FUSE

The battery charger ALTAIR WBPC-200 is set to operate at 230V, 50-60Hz and at 115V,

50-60Hz.

Make sure that the unit is disconnected of the mains.

In the unit rear panel, is placed the mains connector, the mains selector and the fuse

holder. The box bellow this mains connector is called fuse holder + mains selector. Take out

the fuse holder + mains selector.

Upon extracting the fuse holder, the fuse will appear, take out it and change for the new

one.

Insert the fuse holder into the mains connector again, without spin it (make sure that the

voltage to which it is going to connect the unit remains indicated in normal position, not

inverted), if you only wants to change the fuse. If what you want are change the mains

voltage, rotate the fuseholder until remains the mains voltage to which it is going to connect

the unit in normal position, not inverted.

Battery charger ALTAIR WBPC-200 set up to 115

Battery charger ALTAIR WBPC-200 set up to 230

1 2 ... 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Altair EF-200 Anleitung zur Fehlerbehebung Seite 12