8
BP-200 SINGLE CHANNEL WIRELESS BELTPACK.
beltpack turn to indicate the sidetone gain. There are 10 steps of volume, the LOW
BATTERY led indicates the first step, the BUZZ ON/OFF led indicates the fourth step,
the MIC ON/OFF led indicates the seventh step and the IN RANGE led the tenth step of
the mic gain.
The SIDETONE GAIN, it is stored in the unit. Press again to switch on the buzzer..
BELTPACK REGISTRATION
Each beltpack can be registered in two different base stations, so that if it loses the range
of one, changes the operation to the other base station. Each base station can register a
maximum of four beltpacks. See the WBS-200 owners manual for details.
With the base station turned on, press and hold the REGISTER base station switch
during six seconds. At this moment the base station will sound (if the buzzer it is turned on)
and will blink the IN-RANGE (1-2-3-4) leds corresponding where is going away to register the
new beltpack. If the base station has registered four cases already, the function will be reset,
and new beltpacks will not be able to be registered until the deregistration of some beltpack is
made or deregister all the beltpacks registered in the base station (consults the base station
WBS-200 manual for the more information).
If we do not do anything during 60 seconds the function will be reset.
If we pressed key REGISTER again the function will be reset.
With the beltpack that we want to register turned off, turn on pressing the
ON/OFF switch maintaining pressed the VOLUME UP/DOWN
switches (to register it in base 1) or maintaining pressed the
VOLUME UP/DOWN and the BUZZER ON/OFF switches
(to register it in base 2).
If everything goes well, the base station base will sound (if the
buzzer it is turned on) and the beltpack also (if the buzzer it is turned on), the corresponding
base station IN RANGE led will turn on and the beltpack IN RANGE led begin to blink.
If the procedure fails, turn off the base station and the beltpack and start again.
Registering process must be near the base station and is not allowed during battery
charging.
BELTPACK DEREGISTRATION
With the base station turned on, and the beltpack that is wanted to
deregister turned off, turn on the beltpack pressing the ON/OFF switch maintaining
pressed the MIC ON/OFF and the BUZZER ON/OFF
switches.
The beltpack will start normally, but when it is
connected to the base station, this one will be reset and the beltpack will be deregistered.
If the procedure fails, turn off the base station and the beltpack and start again.
DC-IN CONNECTOR
The three NiMh, AAA, 900 mA/h batteries of the wireless beltpack must be charged with
the ALTAIR WBPC-200 charger by the DC-IN connector. The polarity is tip positive.
Charging time is three hours with the batteries empty. After this 2-3 hours time, the
charger sets to trickle (maintenance) mode and can be left alone in the charger. For a full
charge, it is recommended a 2 hours minimum charging in this state.
The estimated battery life, in full duplex mode is 10 hours and 50 hours in standby mode,
with full charged batteries.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern