6
BP-200 SINGLE CHANNEL WIRELESS BELTPACK.
MIC ON/OFF/PUSH TO TALK SWITCH (TALK)
The MIC switch allows to enable/disable the microphone, so that
we are able to speak with other units connected to the same intercom
channel.
If the microphone is activated, its associated LED will light up, and on the other hand, if it
is disabled, its associated LED will turn off.
The MIC switch has two operation modes. When this switch is pressed quickly the
microphone changes its state, if it was enabled, upon being pressed it gets disabled and turns
off the associated LED, and if it was disabled, upon being pressed gets enabled and turns on
the associated LED.
When the MIC switch is pressed and held, the unit will enter in the special function PUSH
TO TALK, this means that the microphone will be enabled until the switch is released.
The unit provides a MIC-KILL (turns off the MIC) system, so that when the mic is enabled
it is possible to muted it by the MIC-KILL function of the base station ALTAIR WBP-200 or a
master station EF-200, connected to the base station. This MIC-KILL system is compatible
with other intercom systems of the market.
The state of the MIC (on/off), it is stored in the unit.
BUZZER ON/OFF SWITCH
This switch enables/disables the buzzer sound when the unit receives a
call and when the user press a key. Whenever this switch is pressed, and the
buzzer is enabled, it will be disabled, and the LED indicator will turn off. On the other hand, if
the buzzer was disabled, it will be enabled and the LED indicator will lighten up.
The buzzer also sounds when any switch is pressed, emitting a short hoot, when it is
enabled.
The unit provides a BUZZER-KILL (turns off the BUZZER) system, so that when the
buzzer is enabled it is possible to muted it by the BUZZER-KILL function of the base station
ALTAIR WBP-200 or a master station ALTAIR EF-200, connected to the base station. This
BUZZER-KILL system is compatible with other intercom systems of the market.
The BUZZER could be disabled with an internal preset. In order to obtain more
information, consult the special operation section.
The state of the BUZZER (on/off), it is stored in the unit.
VOLUME UP/DOWN SWITCH
The volume switches allows attenuating or amplifying the signal
sent to the headphones. This switches adjusts the listen level to the
headphones as you wish.
When volume UP/DOWN switches are pressed, the four leds of the beltpack turn
to indicate the volume. There are 10 steps of volume, the LOW BATTERY led indicates
the first step, the BUZZ ON/OFF led indicates the fourth step, the MIC ON/OFF led
indicates the seventh step and the IN RANGE led the tenth step of volume.
The VOLUME, it is stored in the unit.
ON/OFF SWITCH
When the beltpack is power off, and the beltpack’s on/off switch it is pressed,
all the beltpack leds light on and last a little while it will sound the buzzer (if buzzer
is turn on) and will vibrate (if the vibrator is turn on), indicating that it is
operative.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern